Fixing The Hood - AEG 502 D Operating And Installation Instructions

Fixing After having adjusted the hood for the version required, it may be
installed.
the hood
This appliance is designed for fitting in a cabinet or some other
support.
The opening to be made on the bottom of the wall-hung cabinet
must correspond with the measurements shown in fig. 4
(495 X 260 mm).
To fix the hood proceed as follows:
a) remove the grid.
b) Fit the hood into the opening.
c) Secure the unit to the cabinet by screwing up screws through
holes C (fig. 4).
d) Replace the grid.
C
C
4
10