AEG 570 D Operating And Installation Manual
Hide thumbs
Also See for 570 D:
- Operating and installation instructions (20 pages) ,
- Operating and installation manual (19 pages) ,
- User manual (128 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for AEG 570 D
Summary of Contents for AEG 570 D
- Page 1 570 D - 5708 D Cooker Hood Operating and Installation Instructions...
-
Page 2: Table Of Contents
Contents Safety warnings ................3 For the user ..................3 For the installer ................... 4 Description of the Appliance ............6 Extraction version ................6 Recirculation Version ................6 Control Panel ..................7 Maintenance and Care ..............8 Cleaning the hood ................8 Metal grease filter ................ -
Page 3: Safety Warnings
Safety warnings For the user • The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. -
Page 4: For The Installer
For the installer • When used as an extractor unit, the hood must be fitted with a 120mm diameter duct. Only 5708 D: this model is equipped with two outlet hole. 2 ducts are therefore necessary for discharging the fumes. •... - Page 5 • When the hood is used in its extractor function, the following rules must be followed to obtain optimal operation: - short and straight outlet ducting - keep bends in outlet ducting to a minimum - never install the ducts with an acute angle, they must always follow a gentle curve.
-
Page 6: Description Of The Appliance
Only 5708 D: this model is equipped with two outlet hole. 2 ducts are therefore necessary for discharging the fumes. Coupling ring Bayonet screw fitting 570 D (1x) - 5708 D (2x) Fig. 1 Recirculation Version • The air is filtered through charcoal filters and returned to the kitchen. -
Page 7: Control Panel
• the motor switch switches the motor on and off, enabling you to select one of the three different speeds. Light switch = Light OFF = Light ON Motor switch = Sliding speed control Booster 1 (Only 570 D) Booster 1+2 (Only 5708 D) Fig. 3... -
Page 8: Maintenance And Care
Maintenance and Care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood • Clean the outside of the hood using a damp cloth and a mild deter- gent. • Never use corrosive, abrasive or flammable cleaning products. •... -
Page 9: Charcoal Filter
Charcoal filter • The charcoal filter should only be used if you want to use the hood in the recirculation function. • To do this you will need an original charcoal filter (available from your local Service Centre). • Replacing the charcoal filter Type 150 This filter cannot be cleaned or reused. -
Page 10: Changing The Light Bulb
Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. -
Page 11: Something Not Working
Something Not Working If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood Check that: The hood is connected to will not start... the electricity supply. Check that a fan speed has been selected The cooker hood Check that: The fan speed is set... -
Page 12: Technical Specifications
5708 D 515 mm 715 mm 510 mm 710 mm 548 mm 748 mm Fig. 7 570 D - 5708 D Mounting accessories included 1 allen spanner (for TORX screws) 1 cover 1 flange 2 screws 2,9 x 13 mm (for relocating the control unit) -
Page 13: Installation
Electrical connection Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. - Page 14 Fig. 8...
-
Page 15: Removing The Hood From Cabinet
Removing the hood from cabinet Follow these steps: • Remove the grease filter. • Remove the 4 additional screws from the frame. • Loosen the screws on the two fixing springs. Fig. 9. Fig. 9 • Push a flat screwdriver into the hole for the fixing springs (right and left) and push each of the fixing springs inwards. - Page 16 Relocating the control unit The control unit can be fitted at a different point (cladding, lighting facia, etc.). Remove the grease filter grill and the housing frame. 1. Loosen two screws and pull the control unit forwards out of the housing.
- Page 20 USD 14 billion in more than 150 countries around the world. AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG LI2VDA Ed. 03/06...