Changing The Light Bulb - AEG SANTO K 9 88 00-4 i Operating And Installation Manual

Symptom
The compressor does not
start immediately after
changing the temperature
setting.
Temperature cannot be set
Water on the floor or on
storage shelves.
Changing the
Warning! There is a risk of electric shocks! Before changing the light
bulb, switch off the appliance and unplug it, or disconnect from the
mains supply.
Light bulb data: 220-240 V,
1. To switch off, press the ON/OFF button until the mains power light
goes out.
2. Unplug the mains plug.
3. To change the light bulb,
rear hook and at the same time slide the
cover in the direction indicated by the
arrow.
4. Change the faulty light bulb.
5. Replace the light cover by sliding it
into its original position.
6. Switch the refrigerator back on.
Possible Cause
This is normal, no error has
occurred.
COOLMATIC function
switched on.
Water drain hole is
blocked.
Light Bulb
max. 25 W
press on the
What to do if ...
Remedy
The compressor starts after
a period of time.
Switch off COOLMATIC
manually, or wait to set
the temperature until the
function has reset auto-
matically (refer also to
COOLMATIC section).
See the "Cleaning and
Care" section.
21