Removing The Stabilisers; Opening The Chassis - NEC PowerMate ML5 Disassembly Manual

Removing the Stabilisers

To remove the stabilisers follow the next steps:
1. Place the computer body with the bottom side protruding a little away from the edge of a
table.
2. Free the locks C and slice the stabilisers as indicated by the arrows A and B, towards the
front of the system for stabiliser A and towards the rear for stabiliser B,.

Opening the Chassis

To open the chassis, first remove the stabilisers (see
the next steps:
1. Put the chassis in horizontal position, rear side towards you.
2. Unlock the two cover locks shown in the picture below.
3. Slide the cover towards the front of the chassis a few centimetres, then carefully lift the
cover away from the system and set it aside.
Fig. 1: Removing the stabilisers
Fig. 2: Unlocking the cover of the chassis
NEC PowerMate ML5 Disassembly Manual
Removing the Stabilisers), then follow
Page 5