3. Take the second serial port out of the chassis and put it aside.
Removing the Switch/LED board
To remove the Switch/LED board, first remove the stabilisers (see
open the chassis (see
1. Disconnect the cable from the Switch/LED board.
2. Remove one screw.
3. Carefully remove the Switch/LED board from the chassis and put it aside.
Note: To remove also the cable of the Switch/LED board, the IDE cables must be disconnected from the
motherboard, as they cover the cable of the Switch/LED. In order to easily reach the IDE cables it is
better to first remove the floppy disk drive (see
Removing the Internal Speaker
To remove the internal speaker, first remove the stabilisers (see
open the chassis (see
1. Remove the screws and the connector shown in the picture
Fig. 19: Removing the second serial port
Opening the
Chassis), then follow the next steps:
Fig. 20: Removing the Switch/LED board
Removing the Floppy Disk
Opening the
Chassis), then follow the next steps:
NEC PowerMate ML5 Disassembly Manual
Removing the
Stabilisers),
Drive).
Removing the
Stabilisers),
X2
X1
Page 13