Magnet Mounting The Switch; Connecting The Network - NETGEAR FS2105 Installation Manual

Magnet Mounting the Switch

Inserting the Magnet
Removing the Magnet

Connecting the Network

To connect devices to the switch:
1. Connect the devices to the 10/100 Mbps ports on the switch, using
category 5 UTP cable with an RJ-45 plug.
Note: Ethernet specifications limit the total cable length between
your PC and the switch to 328 feet (100 meters).
2. Connect the switch for specific devices:
• To connect to a PC or router, use port 5 Normal (or port 8 Normal). This
connection is considered "normal."
• To connect to a hub or another switch, use port 5 Uplink (or port 8
Uplink). This connection is considered "uplink."
3. Connect one end of the DC power adapter cable to the power outlet on
the rear panel of the switch and the other end of the power adapter
cable to the wall outlet. Verifying
Model FS2105/FS2108 Fast Ethernet Switch Installation Guide
1
1
2
9640FA
2
9641FA