Installation Guide for the Model FS518 Fast Ethernet Switch
Hold the switch with the mounting holes in the brackets aligned with the holes in the
4.
rack.
Figure 4-1.
Attaching Mounting Brackets to the Model FS518 Switch
Insert two pan-head screws with nylon washers through each bracket and into the rack.
5.
Using a #2 Phillips screwdriver, tighten the screws to secure the switch to the rack.
6.
For proper ventilation, make sure that the switch has at least 2 inches of space on each side and
5 inches of space at the back. It is very important that the fans located in the rear panel are not
blocked.
Caution: Restricted airflow could cause overheating of the components.
To connect additional switches or other devices, refer to
4-4
8945FA
"Connecting Devices to the
Switch."
Installation