Packet Data Settings - Nokia N79 User Manual

Security settings for 802.1x and WPA/WPA2
WPA/WPA2 — Select the means of
●
authentication: EAP to use an extensible
authentication protocol (EAP) plug-in, or
shared key to use a password. Complete the
appropriate settings:
EAP plug-in settings
●
your service provider instructs.
Pre-shared key — Enter a password. The
●
same password must be entered on the WLAN
access point device.
WPA2 only mode — Only WPA2 enabled devices
●
are allowed to establish a connection in this
mode.
Advanced WLAN settings
Select Options Advanced settings
>
following:
IPv4 settings — Enter the IP address of your
●
device, the subnet IP address, the default
gateway, and the IP addresses of the primary and
secondary DNS servers. Contact your internet
service provider for these addresses.
IPv6 settings — Define the type of DNS address.
●
Pre-
— Enter the settings as
and from the
Ad-hoc channel (only for Ad-hoc) — To enter a
●
channel number (1-11) manually, select
defined.
Proxy server address
●
the proxy server.
Proxy port number
●
number.

Packet data settings

Press , and select Tools
Connection Packet data.
>
The packet data settings affect all access points
using a packet data connection.
Packet data connection
●
available and you are in a network that supports
packet data, the device registers to the packet
data network. Starting an active packet data
connection (for example, to send and receive e-
mail) is quicker. If there is no packet data
coverage, the device periodically tries to
establish a packet data connection. If you select
When needed, the device uses a packet data
connection only if you start an application or
action that needs it.
Settings
User
— Enter the address for
— Enter the proxy port
Settings
> >
— If you select When
189