Camera
until you change them again. To adjust the setup
settings, use the options in the active toolbar.
"Colour and lighting settings", p. 96.
the main settings, in the image or video mode,
select
Options
> Settings.
Still image camera settings
To change the main settings, in the image mode,
select
Options
>
Image quality
●
camera only). The better the image quality, the
more memory the image consumes.
Add to album
●
Photos.
Record location
●
coordinates to each image file, select Yes.
Receiving a GPS signal may take time or the signal
may not be available.
information", p. 90.
Show captured image
●
view the captured image after it is taken or to
continue image capturing immediately.
Default image name
●
name for the captured images.
Extended digital zoom
●
available in the main camera.
96
To change
Settings
and from the following:
— Set the resolution (main
— Save the image to an album in
— To add GPS location
See "Location
— Select whether to
— Define the default
— The setting is only
On (continuous)
allows the zoom increments to be smooth and
See
continuous between digital and extended digital
zoom,
On (paused)
to pause at the digital and extended digital step
point, and
Off
while retaining the image resolution. Use the
extended zoom only when getting closer to the
subject is more important than the final image
quality. The overall quality of a digitally zoomed
image is always lower than that of an unzoomed
image.
Capture tone
●
you capture an image.
Memory in use
●
images.
Rotate image
●
images that are captured when the device is held
upright to be rotated when you open them in
Gallery.
Restore camera settings
●
settings to default values.
Colour and lighting settings
In the active toolbar, select from the following:
Flash mode
( ) (image only) — Select the
●
desired flash mode.
allows the zoom increments
allows a limited amount of zoom
— Set the tone that sounds when
— Select where to store your
— Select whether you want
— Restore the camera