Adding Or Replacing Memory Modules - Packard Bell EasyNote NS11HR Service Manual

Adding or replacing memory modules

Tools you need to complete this task:
Screws removed during this task:
www.packardbell.com
Important
Use only memory modules designed for this notebook.
Phillips #0 screwdriver
•
3 black M2.5×6 (bay cover)
To add or replace memory modules:
1
Complete the steps in
2
Complete the steps in
3
If you are replacing a memory module, go to
If you installing an additional memory module, go to
4
Use a non-marring plastic scribe to push out the latches on both sides of
the memory slot until the module tilts upward (1), and then remove the
memory module from its slot (2).
5
Insert the new memory module at a 30° angle into an empty memory slot,
and then press it down until it clicks into place.
The module is keyed so it can only be inserted in one direction. If the module
does not fit, make sure that the notch in the module lines up with the tab in
the memory slot.
6
Reinstall the bay cover.
Non-marring plastic scribe
"Preparing the notebook" on page
"Removing the bay cover" on page
37.
39.
step 4.
step 5.
45