Advertisement
Menu and Sub-menu Definitions
Clear Errors
Erases the contents of the error buffer. Select the CLEAR ERRORS menu item and press the cursor LEFT or
cursor RIGHT key. The contents of the error buffer are cleared.
The functionality of the OPTIONS and ALIGNMENTS (TUNER, WHITE TONE, GEOMETRY, SOUND, and
SMART SETTING) sub-menus are described in the service adjustments.
Error code buffer and error codes
Explanation of the Error code buffer
The error code buffer contains all errors detected since the last time the buffer was erased. The buffer is
written from left to right. When an error occurs that is not yet in the error code buffer, the error code will
appear at the left side and all other errors shift one position to the right.
The error code buffer will be cleared in the following cases:
by activating CLEAR ERRORS in SAM menu
exiting SDM or SAM with the "Standby" command on the remote control
upon automatic reset when content has not changed for 50 consecutive hours
By leaving SDM or SAM via the power switch, the error buffer will not be reset.
Examples:
ERROR: 0 0 0 0 0 0 0 : No errors detected
ERROR: 6 0 0 0 0 0 0 : Error code 6 is the last and only detected error
ERROR: 9 6 0 0 0 0 0 : Error code 6 was first detected and error code 9 is
The contents of the error buffer can also be displayed by use of the "blinking LED" procedure, if no picture is
available. See explanation of "The blinking LED procedure "below.
Error code definition
In case of non-intermittent faults, clear the error buffer before starting the repair. Make sure "old" error codes
are not present. If possible check the entire content of the error buffers. In some situations an error code is only
the result of another error code (and not the actual cause).
Note: A fault in the protection detection circuitry can also lead to a protection.
Error codes 1,2, 3, and 4 are protection codes, and in this case the supplies of some circuits will be switched off.
Also in protection, the LED will blink the number of times equivalent to the most recent error code.
the last detected (newest) error
Advertisement
