Advertisement
Geometry settings are located in the GDE SAM mode. Press the Cursor down button to highlight the GDE SAM
then press the Right Cursor button to select. The following menu will appear:
If the CRTs have been replaced, a Screen Centering adjustment will be necessary. Apply a crosshatch pattern
to the set. Cursor Down to CONV PROC in the menu and press the Right Cursor button to select. This will
disable the Convergence drive. Select Geometry in the menu and enter the following default values for the
mode being adjusted. Other mode values can be entered by selecting a different DISPLAY MODE in the menu.
In most cases, no additional adjustment will be necessary.
Advertisement
