Download  Print this page

Whirlpool 2180911 Installation Instructions

Automatic ice maker.
Hide thumbs
   

Advertisement

IMPORTANT:
Read and save
these instructions.
IMPORTANT:
Installer: Leave Installation Instructions
with the homeowner.
Homeowner:
Keep Installation Instructions
for future reference.
Save
Installation Instructions for local
electrical
inspector's use.
Automatic
Ice Maker
u
Part No. 2180911

Advertisement

   Related Manuals for Whirlpool 2180911

   Summary of Contents for Whirlpool 2180911

  • Page 1 IMPORTANT: Part No. 2180911 Read and save these instructions. IMPORTANT: Installer: Leave Installation Instructions with the homeowner. Automatic Homeowner: Keep Installation Instructions for future reference. Ice Maker Save Installation Instructions for local electrical inspector’s use.
  • Page 2 Before you start... It is the customer’s responsibility to: Drain system requires either a gravity floor-drain system or a drain pump (see Observe all governing codes and “Drain requirements”) to lift the water to ordinances. an existing drain. A l-l /4” minimum Comply with the installation diameter standpipe or 5/8”...
  • Page 3 Electrical Water requirements screw requirements The cold water line to the ice maker must be l/4” O.D. soft copper tubing. Use the threaded compression fitting to connect the water line to the ice maker inlet valve. Install a shutoff valve in the water line where it can be easy to access Preparation steps: 1 a Put on safety glasses and gloves.
  • Page 4 To change lower panel: Changing the n If installina decorative wood 1. Remove three screws attaching lower bin door and panels on the door azd lower panel, panel assembly to ice maker. follow the “Changing the bin door and Remove two screws at top of lower lower panel lower panel”...
  • Page 5 This de-energizes all the system except for the transformer and BK/W BLACK/WHITE TRACER cutter grid. GREEN/YELLOW TRACER ’ Note: Door switch and bin light not Part No. 2180911 Printed in U.S.A. used on all models. 0 1995...

Comments to this Manuals

Symbols: 0
Latest comments: