Table of Contents
Advertisement
Vax VEC-01&02 User Guide.qxd
Return the pre-motor filter to the vacuum cleaner and
close the vacuum cleaner lid.
Post-motor Filter
NOTE: This is located on the back of the vacuum cleaner.
Release the post-motor cover by pressing down on the
two catches at the top of the cover (Fig.6/9).
Fig.6/9
Remove the filter by pulling away from the casing
(Fig.6/10).
Fig.6/10
The post-motor filter can be rinsed in warm water (max
40°C). Allow to air dry for at least 24 hours before
replacing
Return the post-motor filter to the casing and re-fit to the
back of the vacuum cleaner.
27/9/07
17:17
Page 7
7. Clearing Blockages
WARNING: To reduce the risk of electric shock,
!
the power cord must be disconnected before
performing maintenance or troubleshooting checks.
Turn the vacuum cleaner off and unplug from the electrical
outlet.
The flexible hose can be disconnected from the vacuum
cleaner by rotating 90 deg. Anti-clockwise, until the hose
lugs line up with spacers and then pull away from the
machine. Remove any blockages found then re-connect
the hose securely.
Removing debris from the TurboTool
Switch the vacuum cleaner off and disconnect the power
plug from the electrical outlet.
Rotate the locking ring 180º (Fig.7/1).
Fig.7/1
Lift the top cover off and remove any blockage (Fig.7/2).
To re-assemble, ensure that the tabs are engage. Pivot the
lower housing closed and rotate the locking ring 180º
(Fig.7/2).
Fig.7/2
dirt container & filter / clearing blockages
Vax Careline
0870 606 1248
(Model: VEC-02 only)
LOCKING RING
TABS
7
Advertisement
Table of Contents
