Vax Floormate V-120 Instruction Manual page 7

Vax V-120 User Guide.qxd
Check for worn spots or joint separations before using, as
these conditions could lead to damaged flooring when
using water to clean floor.
Pour cleaning solution into tank (A). Fill tank to fill line (B)
with warm water (Max 40°C) (Fig.4/6).
B
Fig.4/6
If rubber ring (A) on cap has become dislodged, reposition
it with uneven side against ledge (B) as shown (Fig.4/7).
Fig.4/7
Replace cap. Rotate cap clockwise until it locks in place.
Cap must be locked in place for proper performance and to
prevent leaking (Fig.4/8).
Fig.4/8
Slide tank straight into position until latch snaps in place
(Fig.4/9).
9/10/07 12:43 Page 7
A
Fig.4/9
Emptying the Recovery (Lower) Tank
An automatic suction shut-off is built into the recovery
tank to prevent the tank from overflowing. When the shut-
off activates, the cleaner will not pick up debris and the
sound of the motor will change. The recovery tank is full
and must be emptied.
Turn cleaner off and disconnect from electrical outlet.
Although not necessary for satisfactory performance, it is
recommended that the recovery tank be emptied after dry
vacuuming and before wet operation. Check the solution
A
tank also. It may need to be refilled at this time.
To remove tank, press down on release button (A) and pull
tank straight out (Fig.4/10).
B
Fig.4/10
Remove tank lid (A) (Fig.4/11). Empty tank.
Fig.4/11
Vax Careline 0870 606 1248
A
A
operation
7