UNI-T UT601 Operating Manual page 14

4.
When measuring small value capacitor, that is 200pF,
2nF and 20nF, first open circuit the test clips or the
Small Value Capacitance Jack, then turn the
Capacitance Zero Adjustment Switch to adjust zero.
5.
The measured value shows on the display.
Note
l
Do not short the test clips to avoid the consumption of
battery.
l
To minimize the effect of capacitance stored in the test
clips, the test clips should be as short as possible and
use the Small Value Capacitance Jack when measuring
small value of capacitance.
l
When capacitance measurement has been completed,
disconnect the connection between the testing clips and
the circuit under test and remove the testing clips away
from the input terminals of the Meter.
Model UT601: OPERATING MANUAL
14