Model UT60B/C/E: OPERATING MANUAL
Unpacking Inspection
Open the package case and take out the Meter. Check the
following items carefully to see any missing or damaged part:
Item
Operating Manual
1
Test Lead
2
Test Clip
3
4
Model UT60C/UT60E:Point
Contact Temperature Probe
5
9V Battery (NEDA1604, 6F22 or 006P)
(installed)
Model UT60E:RS232C Interface Cable
6
7
Model UT60E:CD-ROM (Installation
Guide & Computer Interface Software)
In the event you find any missing or damage, please
contact your dealer immediately.
Safety Information
This Meter complies with the standards IEC61010: in
pollution degree 2, overvoltage category (CAT. III 1000V,
CAT. IV 600V;)and double insulation.
CAT. III: Distribution level, fixed installation, with smaller
transient overvoltages than CAT. IV
CAT IV: Primary supply level, overhead lines, cable
systems etc.
Use the Meter only as specified in this operating manual,
otherwise the protection provided by the Meter may be
impaired.
In this manual, a Warning identifies conditions and
actions that pose hazards to the user, or may damage
the Meter or the equipment under test.
A Note identifies the information that user should pay
attention on.
International electrical symbols used on the Meter and
in this Operating Manual are explained on page 6.
Description
4
Qty
1 piece
1 pair
1 pair
1 piece
1 piece
1 piece
1 piece