Square Wave Output - UNI-T UT33B Operating Manual

Note
l
When battery testing has been completed, disconnect the connection between
the testing leads and the circuit under test.
H. The Model UT33D: Square Wave Output
Warning
To avoid damages to the Meter, do not allow output terminals (red test lead)
to reach higher than 10V.
To measure square wave output proceed as follows:
1. Set the rotary switch to
2. The square wave signal outputs between V mA and COM Terminals.
Note
l
The frequency is approx. 50Hz.
l
The output scope higher than 3Vpp when it is loaded 1M
Model UT33B/C/D: OPERATING MANUAL
Measurement Operation (16)
OUT.
28