Alarm; Square Wave Output; Operating Instruction - UNI-T UT2000 Operating Manual

13. Alarm

ALARM SOUNDS
Switch position Test leads position
Mis-
V, ,Hz,
BATT
operation
A,mA,2A
10A
Over
Display >19999*
range
The testing value for

14. Square wave output

Frequency approx. 50Hz, range Vp-p 2V (only
for UT2001).
OPERATING INSTRUCTIONS
1. Check the 9V battery by press down the ON
- OFF SWITCH. If the battery is weak,"
sign will appear on left bottom side of the
display. The sign
jacks is for warning that the input voltage or
current should not exceed the indicated values.
This is used to prevent the damage to the
internal circuitry. The function switch should
be set to the range which you want to test
before operation.
2. Except capacitance, transistor hFE and
temperature which use the special test jack,
the input terminal for all other range should
be "V/ ", "COM" being the input earth terminal.
Model UT2000: OPERATING MANUAL
,
A or 10A
10A
A
range is meaningless.
next to the test lest lead
13
"