TYAN Thunder K8W S2885 User Manual page 18

Heatsink Installation Procedures
Type A: CAM LEVER (TYPE) INSTALLATION
1
2
3
Type B: SCREW RETENTION TYPE HEATSINK
1
2
3
Finishing Installing the Heatsink
1. Once you have completed installing the back-
plate and interface material; align the retention
bracket screw hole with CPU back-plate standoffs.
Tighten screws to secure retention bracket.
Repeat for on other side.
DO NOT OVERTIGHTEN.
2. After tightening screws secure metal clip to
plastic retention bracket center tab. Repeat for on
other side of heatsink.
3. After securing metal clip to plastic retention
bracket center tab, push down on plastic clip to
lock plastic clip to side tab.
1. Align the heatsink retention frame screw hole with back-
plate assembly standoffs. Place heatsink inside retention
bracket. Place metal clip over retention frame tab.
2. Insert screw through metal clip. Check that the
heatsink's metal clip is and the tab on the retention frame
are as illustrated.
3. Tighten screw through metal clip. Repeat on other side.
DO NOT OVER TIGHTEN.
18
WWW.TYAN.COM