Brother MFC-7360N User Manual page 106

Error Message
Replace Toner
Scan Unable XX
Size Error DX
Size mismatch
Toner Ended
Toner Low
68
Cause
The machine will stop printing
until you replace the toner
cartridge.
The machine has a mechanical
problem.
The paper in the tray is not a
suitable size for automatic duplex
printing.
The paper in the tray is not a
correct size.
It is time to replace the toner
cartridge.
The toner is low.
Action
If you have set the Toner setting to Stop,
replace the toner cartridge with a new and
unused original Brother toner cartridge. This
will reset the Replace Toner mode. (See
Replacing the toner cartridge on page 53.)
If you have set the Toner setting to
Continue, the machine will continue to
print data until the LCD shows Toner
Ended. For how to operate the machine in
Continue mode, see Toner Settings in
Chapter 1 of the Advanced User's Guide.
(For MFC-7360N and MFC-7460DN )

See Transferring your faxes or Fax
Journal report on page 69 before
disconnecting the machine so you will
not lose any important messages. Then,
disconnect the machine from the power
for several minutes and then reconnect
it.
(For MFC-7860DW)
Disconnect the machine from the power
for several minutes, then reconnect it.
 If the problem continues, call Brother
Customer Service.
Load either Letter, Legal or Folio paper for
automatic duplex printing, and then press
Start. (See Print media on page 127.)
Load an appropriate size of paper in the
tray, and re-set the "Paper Size" (Menu, 1,
2, 2). (See Paper Size on page 17.)
Replace the toner cartridge with a new one.
(See Replacing the toner cartridge
on page 53.)
Buy a new toner cartridge before you get a
Replace Toner message.