Advertisement
NORMAL OPERATION
Plug unit into an appropriate electrical receptacle.
Add water to water pan. Proper water level is 1/2" from top.
OPERATIONAL TIPS:
Refill water pan as required during operation.
Use filtered or treated water to minimize mineral/scale build-up.
Keep drawer(s) closed to minimize water usage.
Press power switch to ON. Allow unit to pre-heat for 20 minutes.
Press the MENU key to display parameters (AIR temperature, WATER
temperature or TIME setting) for the current menu.
Select parameter (AIR temperature, WATER temperature or TIME)
to be displayed by pressing SEL key. The corresponding indicator will
glow. Display will default to AIR temperature if no key is pressed for
5 seconds.
Change menu by pressing the MENU key at the same time as the UP
ARROW or DOWN ARROW key. Any one of a maximum of eight
menus may be displayed.
NOTE: Settings for AIR temperature, WATER temperature and
TIME may only be changed in the program mode. Normal setting
information is shown on the control panel chart.
TEMPERATURE AND HUMIDITY SETTINGS
HIGH HEAT
AIR
WATER
MOISTURE
ºF (ºC)
ºF (ºC)
190 (88)
190 (88)
HIGH
190 (88)
160 (71)
MEDIUM
190 (88)
130 (54)
LOW
MEDIUM HEAT
AIR
WATER
MOISTURE
ºF (ºC)
ºF (ºC)
160 (71)
160 (71)
HIGH
160 (71)
145 (63)
MEDIUM
160 (71)
130 (54)
LOW
LOW HEAT
AIR
WATER
MOIS-
ºF (ºC)
ºF (ºC)
TURE
140 (60)
140 (60)
HIGH
140 (60)
135 (57)
MEDIUM
140 (60)
130 (54)
LOW
7
OPERATION (continued)
CAUTION:
HOT SURFACE
Exposed surfaces can be hot
to the touch and may cause
burns.
CAUTION:
ELECTRICAL
SHOCK HAZARD
DO NOT splash or pour water
onto control panel or wiring.
The controller incorporates a
single TIME setting.
Press MENU key, then
START/STOP key to start
timer. An audible alarm will
sound at the end of the time
period.
Time is factory set at 2hr.
Time setting can be changed
in program mode.
Timer can be set from 0:00 to
a maximum of 6:00.
Advertisement
