Dsc Programming - Blaupunkt Malaga RCR 127 Operating Instructions Manual

DSC programming

DSC (Direct Software Control) allows you
to customise certain programmable, basic
settings to suit your personal needs and
preferences and then store them.
The basic settings for this audio equipment
were made at the factory.
In the following you can find an overview of
these settings, so that you can always reset
to these if desired.
If you wish to alter any of the programming,
• press SRC to select one of the operat-
ing modes radio or cassette (e.g. ra-
dio, if you wish to change the language
with PTY LANG).
• press DSC.
Use the rocker switch to select and adjust
the functions described in the following. The
display will show you the adjusted condition.
/ Select function
<< >> Adjust/recall value
40
AM ON / OFF You can deactivate one or
both AM bands (MW/LW) in
order to reduce the number
of bands for selection with
BND.
selectable:
AM ON – all bands
MW OFF – LW, FM
LW OFF – MW, FM
AM OFF – FM
RM ON / OFF (Radio Monitor)
(RM ON/OFF appears only
in the cassette mode)
Allows you to listen to the
radio during fast winding of
the tape.
RM ON – Radio playback
activated
RM OFF – Function deacti-
vated
VOL FIX Use this function to select
the volume at which the ra-
dio is set when it is switched
on. Adjust the desired vol-
ume level with << >>. If
"VOL 0" is set, the system
will come on with the vol-
ume selected before switch-
ing it off.
S-LO To adjust the seek tuning
sensitivity for local reception
LO 1 - high sensitivity
LO 3 - low sensitivity
The seek tuning sensitivity
values can be set separately
for AM and FM.
S-DX To adjust the seek tuning
sensitivity for distant recep-
tion.
DX 1 - high sensitivity
DX 3 - low sensitivity
PTY LANG To select the programme
type language: DEUTSCH
or ENGLISH
BEEP Acknowledgement tone for
all of the functions which re-
quire a button to be pressed
for more than 1 second.
The volume can be set from
between 0 to 9. (0 = off)