7.1.4
Set the time
In Idle mode:
1. Follow steps 1 to 2 in Section 7.1.1.
2. Press [ Select ] and <UP/DOWN> to scroll to Set Time.
3. Press [ Select ] and enter the time according to the time format you set
in Section 7.1.2.
Note: If incorrect input is detected, an error tone will be emitted and the
cursor will stop at the incorrect input.
4. If in 12-hour mode, press the <*> key to change between AM and PM.
5. Press [ OK ] to confirm.
7.2
Alarm
You can use the iDECT L1i handset as an alarm clock. When an alarm is
set, the <ALARM Icon> is shown on the handset display.
When the alarm time is reached, the <ALARM icon> and " Alarm On "
flash on the display, and the alarm melody is played for 45 seconds or until
any handset key is pressed.
If the snooze function is activated, the alarm will repeat every 2 minutes,
unless <Off> or [Off] are pressed while the alarm is sounding.
Note:
a. A key press will still disable the alarm, even if the handset keypad is
locked when the alarm rings.
b. The alarm volume level setting is the same as the handset ringer
volume. If the handset ringer is set to Volume Off, the alarm still sounds
at Volume 1 level.
c. During an external or internal call, if an alarm is set and the alarm time
is reached, the <ALARM icon> and " Alarm On " will still flash, but there
will be no alarm tone. from the earpiece to alert the user the alarm time
is reached. If the user presses a key to stop the alarm or activate the
snooze, the display will revert to the call duration screen.
d. During ringing, the alarm will not sound when the alarm time is reached,
but if the ringing stops within 45 seconds of the alarm time, the alarm
will sound, and the snooze function will continue, if set.
7.2.1
Turn off the alarm
In Idle mode:
1. Press [ Menu ] and <UP/DOWN> to scroll to Clock/Alarm.
2. Press [ Select ] and <UP/DOWN> to scroll to Alarm.
3. Press [ Select ] and <UP/DOWN> to scroll to Alarm Off.
4. Press [ Select ] to confirm and turn the alarm off.
20
Need help?
Do you have a question about the iDECT L1i System and is the answer not in the manual?