Removing The Fascia And Firefront - Baxi VALOR FIRES 845 Installer And Owner Manual

Dimension electric firefront for use with the baxi bermuda bbu15 he boiler

Table of Contents

INSTALLER GUIDE

7. REMOVING THE FASCIA AND FIREFRONT

To gain access to the boiler for servicing and maintenance it will be necessary to

remove the firefront. Do this as below:

1. Where applicable remove the lower casting from the base of the firefront. Firmly

hold the lower sides of the fascia and gently pull the bottom forward to release the

magnets that hold the bottom in place. Lift the fascia upward and forward until the

fascia hanging brackets are clear of the upper hanging brackets on the firefront. Place

the fascia away from the work area.

2. The firefront is is held in place with a single

wire. It will be necessary to loosen and remove

the wire at one side. Do this by placing a flat

ended screw driver or similar tool behind the

wire loop on the front of the firefront (See figure

10). Push the wire loop towards the outer hole

and pull on the wire where it passes through an

outer hole in the firefront. The wire should

become loose and can then be pulled from the

outer hole. With the end of the wire free, gently

pull the firefront forward.

3. After completing work on the boiler fit the

firefront and fascia as in sections 5 and 6 of this

guide.

Figure 10. To loosen the wire

Baxi Heating U.K. Limited 2009.

Page 15

Table of Contents

Table of Contents