Securing The Firefront; Method A - Securing With Wire - Baxi VALOR FIRES 845 Installer And Owner Manual

Securing the Firefront.

The firefront must be secured into position to prevent it from being tipped over.
The following securing options are available:

Method A - Securing with wire.

Method B - Securing with wire using an Optional Spacer Frame kit (See
section 3).
If fitting the firefront onto a decorative hearth surface such as marble or tile it is
advisable to protect the hearth surface. Do not drag the firefront as the surface finish
may be damaged.
Method A - Securing with wire.
1. Supplied with the firefront is a spacer frame. The
opening for the Boiler Control should be on the right
hand side when fitting.
2. Secure the spacer frame to the firefront using four
No.8 x 3/8 screws supplied (See figures 2 and 4).
3. Insert the Boiler Control lead through the opening in
the spacer frame, then ensuring that the display is at
the top, gently push the Boiler Control into place. The
control will 'click' into place. Place the firefront in front
of the boiler, connect the Boiler Control lead to the
lead on the boiler and check the boiler operation.
4. There is a supply cable slot on both sides of the
spacer frame. It is located at the base. Decide which
side to pass the supply cable through and position the
supply cable in the spacer frame slot.
5. Supplied with the firefront is a steel wire. This will be
used to secure the firefront to the top of the boiler.
6. At the top of the firefront there are four small holes,
two each side of the firefront. From the front of the
firefront, thread about 50mm of the steel wire into the
outside small hole on the right side of the firefront (See
point 1 - figure 6).
7. Thread the other end of the wire through the remaining
small hole to the left. Continue to push the wire through
this hole until there is only a small loop of wire at the
front of the firefront (See point 2 - figure 6).
8. At the back of the firefront there will be a long piece
and a short piece of wire coming through the two holes.
Hold the short piece and give the long piece a gentle tug.
©
Baxi Heating U.K. Limited 2009.
INSTALLER GUIDE
Page 11
Figure 4. Fitting the spacer
frame to the firefront
Figure 5. Fitting the Boiler
Control.