Dispensing Boiler Water Through The Steam Boiler - Baumatic PECM1SS Instruction Manual

o To dispense steam, press the steam boiler dispensing button
(32).
NOTE: Steam will dispense from the pipe for boiling water and
steam (17).
o To stop steam from dispensing, press the same button again.
The noise generated during this operation is perfectly
normal. This is caused by the activation of the high
pressure pump during this operation.
It is also quiet normal for a certain amount of water to
drip into the drip tray after water has been dispensed.
3) Dispensing boiling water through the steam boiler
o Follow the instructions on filling the water reservoir (pages 11 –
14) as stated previously and proceed as follows:-
o Press the steam boiler activation button (31) to allow the boilers
to heat up. During this process, the steam boiler status indicator
(25) will flash.
o Whilst the steam boiler is heating up, it is normal to get a small
amount of water dripping from the pipe (17).
o When the boilers have reached their operating temperature, the
steam boiler status indicator (25) will stop flashing and remain
steady.
o To dispense boiling water, press the boiling water dispensing
button (33).
o WARNING: During
extreme caution
exercised, as the dispensing pipe will
get hot.
o When releasing
directing the steam towards your
person. There
scalding.
o Always use a container or a mug
underneath
whilst dispensing steam.
this operation,
should
steam,
is a danger
the dispensing
be
avoid
of
pipe
16