Table of Contents
Advertisement
4. Getting Started
Image 4-9
Two way hard-wired remote
4.8
Projector address
Overview
•
Address setting
•
Displaying and Programming addresses into the RCU
4.8.1
Address setting
Projector address
Address installed in the projector to be individually controlled.
Common address
Default address. Projector will always execute the command coming from a RCU programmed with that common
address.
Why a projector address ?
As more than one projector can be installed in a room, the separate projector should be separately addressable with an RCU or
computer. Therefor each projector has its own address.
Set up an individual Projector Address.
The set up of a projector address can be done via the software.
Projector controlling.
Every projector requires an individual address between 0 and 255 which can be set in the Installation menu.
When the address is set, the projector can be controlled by :
•
RCU for addresses between 0 and 9.
•
computer, e.g. IBM PC (or compatible), Apple MAC, etc. for addresses between 0 and 255.
A projector will respond to a RCU set to the common address '0' regardless of what address is set in the projector itself (common
address of projector should also be "0" ).
The RCU is default programmed with address 0 , 'common address'.
If it is necessary to control a specific projector, then enter the projector address into the RCU (only when that
address is between 0 and 9). The projector with the corresponding address will listen to that specific RCU.
Some projectors may operate in domestic environments where other equipments may listen to the common
address "0" , therefore the common address can also be set to "1".
40
R5976629 BARCORLM G5 02/06/2006
Advertisement
Table of Contents
