Preparation - Friedrich MW09Y3FM Operating Manual

PREPARATION

Turn on the Power
1 In the case of a direct line connection, turn on the cir-
cuit breaker.
Load Batteries (AAA/R03/LR03 × × × × × 2)
1 Press and slide the battery compartment lid on the re-
verse side to open it.
Slide in the direction of the arrow while pressing the
2 Insert batteries.
Be sure to align the battery polarities (
3 Close the battery compartment lid.
Set the Current time
Press the CLOCK ADJUST button (Fig. 5 S).
1
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET (
adjust the clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
one-minute increments; hold the buttons depressed to change the time
quickly in ten-minute increments.)
Press the CLOCK ADJUST button (Fig. 5 S) again.
3
This completes the time setting and starts the clock.
To Use the Remote Control Unit
G The Remote Control Unit must be pointed at signal receiver (Fig. 1 4) to operate
correctly.
G Operating Range: About 7 meters.
G When a signal is properly received by the air conditioner, a beeping sound will
be heard.
G If no beep is heard, press the Remote Control Unit button again.
Remote Control Unit Holder
Insert
Press in
Screws
1 Mount the Holder. 2 Set the Remote Control
Unit.
mark.
) correctly.
) buttons (Fig. 5 K) to
/
Slide up
Pull out
3 To remove the Remote
Control Unit (when use at
hand).
CAUTION!
G Take care to prevent infants from
accidentally swallowing batteries.
G When not using the Remote Control Unit
for an extended period, remove the
batteries to avoid possible leakage and
damage to the unit.
G If leaking battery fluid comes in contact
with your skin, eyes, or mouth, immedi-
ately wash with copious amounts of
water, and consult your physician.
G Dead batteries should be removed
immediately and disposed of properly,
either in a battery collection receptacle
or to the appropriate authority.
G Do not attempt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year
under normal use. If the Remote Con-
trol Unit's operating range becomes ap-
preciably reduced, replace the batteries
and press the RESET button with the tip
of a ballpoint pen or other small object.
En-4