Table of Contents
Advertisement
AXIS P5532–E PTZ Dome Network Camera
Hardware overview
Hardware overview
1.
Network connector
2.
Part number (P/N) & Serial number (S/N). Serial number may be required during installation.
3.
Control button
4.
SDHC card slot
5.
Status indicator LED
6.
Restart button
Connectors
Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet Plus (PoE+) IEEE 802.3at. Use the supplied midspan.
Caution
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded network
cable (STP) may be appropriate or required. Any network cables that are routed in outdoor environments or similar shall be
shielded (STP) and intended for their specific use. Make sure that the midspan is properly grounded. See Electromagnetic
Compatibility (EMC) for regulatory requirements.
SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage. For
instructions on how to insert and remove an SD card, please refer to the Installation Guide.
Note
Before removal, the SD card should be unmounted to prevent corruption of recordings. To unmount the SD card, go to Setup
> System Options > Storage > SD Card and click Unmount.
Control button - The control button is used for:
•
Connecting to an AXIS Video Hosting System service. See page 35. To connect, press and hold the button for about
1 second until the Status LED flashes green.
1
2
4
5
3
4
6
Advertisement
Table of Contents
