Hardware Overview; Connectors - Axis P5544 PTZ User Manual

AXIS P5544 PTZ Dome Network Camera

Hardware Overview

Hardware Overview
4
3
1
Part number (P/N) & Serial number (S/N)
2
Network connector (PoE+)
3 Panopsis lens
4
Multi-connector
5
Control button
6
SD card slot
7
Status LED indicator
8
Restart button

Connectors

For technical specifications, see page 57.
Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet Plus (PoE+) IEEE 802.3at. Use the supplied midspan.
NOTICE
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded network
cable (STP) may be appropriate or required. Any network cables that are routed in outdoor environments or similar shall be
shielded (STP) and intended for their specific use. Make sure that the midspan is properly grounded. See Electromagnetic
Compatibility (EMC) for regulatory requirements.
SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage.
NOTICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > System
Options > Storage > SD Card and click Unmount.
Control button - The control button is used for:
• Connecting to an AXIS Video Hosting System service. See page 42. To connect, press and hold the button for about
1 second until the Status LED flashes green.
1
5 6
2
5
7
8