Storage - Axis P5544 PTZ User Manual

AXIS P5544 PTZ Dome Network Camera
System Options
The following traps are available:
• Cold start
• Warm start
• Link up
• Authentication failed
SNMP v3 provides encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.
To use SNMP v3, HTTPS must be enabled, see HTTPS, on page 39. To enable SNMP v3, check the box and provide the initial user
password.
Note
The initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, see
Reset to Factory Default Settings, on page 49.
TM
UPnP
The Axis product includes support for UPnP
systems and clients that support this protocol.
UPnP TM can be disabled under System Options > Network > UPnP
RTP/H.264
The RTP port range and multicast settings are configured under System Options > Network > RTP.
The RTP port range defines the range of ports from which the video/audio ports are automatically selected. For multicast streams,
only certain IP addresses and port numbers should be used.
Select Always Multicast Video and/or Always Multicast Audio to start multicast streaming without opening an RTSP session.
Bonjour
The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
Bonjour can be disabled under System Options > Network > Bonjour.

Storage

SD Card
NOTICE
To prevent corruption of recordings, the SD card should always be unmounted before it is ejected.
Important
To access the SD card, the top cover must be removed. After remounting the alignment of the lens may differ slightly
and the PTZ mechanics should be recalibrated. Go to System Options > Maintenance and click Calibrate PTZ. For more
information, see PTZ Calibration, on page 47.
The Axis product supports SD cards with the following file systems:
• ext4 — recommended due to its resilience against data loss if the card is ejected or if there is abrupt power loss. To access
data stored on the card from the Windows operating system, a third-party ext4 driver or application is required.
• vFAT — most SD cards are pre-formatted with vFAT when purchased.
TM . UPnP TM is enabled by default and the product is automatically detected by operating
TM .
45