Advertisement
3. To terminate the trigger test, push the ON/OFF button on the remote
transmitter.
NOTE: If triggered in the armed mode, the RF-303 will sound the vehicle horn,
or siren and flash the parking lights for 60 seconds. It will then stop and
automatically reset, and rearm. If the violation continues, the alarm will sound
and the parking lights will flash for two (2) sixty second cycles.
J. PROGRAMMING THE REMOTE TRANSMITTERS
The RF-303 includes two (2), 2 button mini remote control transmitters which
must be programmed to the alarm before any alarm function is possible. This
action is normally done at the time of installation, however there may be
occurrences where you wish to enter the program mode.
NOTE: Each time the programming mode is entered, all previously programmed
transmitter codes will be automatically deleted and must be reprogrammed. This
is an important security feature. If any transmitter is lost or stolen, enter the
programming mode and reprogram existing transmitters. Transmitters can only
be programmed by entering the programming mode.
NOTE: Any transmitters programmed to the RF-303 as described above will
remain in memory during times when certain vehicle service procedures make it
necessary to disconnect the battery.
To program the RF-303 transmitters, follow the directions as written below, in
their exact order! HAVE ALL TRANSMITTERS READILY AVAILABLE.
1. Flip the VALET/OVERRIDE switch to its "ON" position.
2. Turn the ignition switch to "ON", then "OFF", then immediately flip the
VALET/OVERRIDE switch "OFF", "ON/OFF", "ON/OFF". The vehicle
horn, or siren will chirp several times.
9
Advertisement
