Advertisement
3. Turn the ignition switch "ON/OFF", "ON/OFF". The vehicle horn, or siren
will chirp again, one (1) time. You are now in the programming mode.
4. Press the ON/OFF button on one of the remote transmitters until the vehicle
horn, or siren responds with a confirming chirp. The first transmitter is now
programmed.
5. Within five (5) seconds, press the ON/OFF button on the second transmitter
until the vehicle horn, or siren responds with a confirming chirp. The second
transmitter is now programmed.
NOTE: If the RF-303 does not receive a second transmitter code to learn
within five (5) seconds, it will automatically close the programming mode and
resume normal alarm functions. If this happens, it will be necessary to repeat
steps 1 through 5 and reprogram all transmitters.
NOTE: The RF-303 can learn up to four transmitter codes. If additional,
optional transmitters are to be programmed, follow sequence 1 through 5 and
continue programming.
L. PROGRAMMING THE REMOTE TRANSMITTERS FOR A
SECOND VEHICLE.
10
Advertisement
