Pitney Bowes 9754 Operator's Manual page 64

Print Queue Scan Rate
Ethernet Frame Type
Disable Bindery
Apply Button Click this button to apply any settings you have
Clear Button Click this button to cancel any settings you have
The settings you make on this screen do not become valid until you
reset the Network Interface Card or power it down and then back up
again. See
8.7 – Reset
Interface Card.
Specify the print server's queue scan interval in
seconds. The default scan rate is 1 second.
Specify the frame type being used by Ethernet.
Normally, the frame type being used by NetWare
is determined by monitoring the Network Interface
Card. When the frame type is determined, it is
assumed that the Network Interface Card is the
same frame type. Once you select a frame type,
Network Interface Card operation supports that
NetWare frame type only.
Frame type monitoring normally starts from IEEE
802.3, and then moves to Ethernet II and then
802.3 SNAP. When the network you are on uses
multiple Ethernet frame types, use the pull-down
menu to select the frame type to be recognized.
Check this option to disable bindery when only the
NDS mode is used. When bindery is disabled, the
Network Interface Card no longer supports the
print server on the bindery file server.
input up to this point.
input up to this point.
for more information on resetting the Network
8 Network Tab
57