Initial Settings; Adjusting Initial Settings; Setting The Fm Tuning Step; Setting The Am Tuning Step - Pioneer AVH-P6450 Operation Manual

Av receiver / cd player with 6.5 inch wide display and av receiver with 6.5 inch wide display
Hide thumbs Also See for AVH-P6450:
Table of Contents

Advertisement

Section

Initial Settings

11

Adjusting initial settings

Initial settings lets you perform initial set up of
different settings for this unit.
1
display
FUNCTION
Shows the function status.
You cannot select AUDIO MENU from the OFF
SOURCE MENU.
1 Press
SOURCE
off.
2 Press
A.MENU
MENU is displayed.
3 Press 5 or ∞ to select
.
A.MENU
(FM tuning step)
FM STEP
(AM tuning step)
AM STEP
DETACH WARNING
(Auxiliary)
AUX
(Rear output and subwoofer)
REAR SP
(Telephone muting)
TEL/GUIDE
You can operate a desired function. For details,
refer to the pages for each of the functions.
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
on the remote control.
WIDE
50
En
1
and hold until the unit turns
and the OFF SOURCE
, and press
INIT
(Warning tone)
BAND/ESC

Setting the FM tuning step

The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Press 5 or ∞ to select
INIT MENU, and press
FM STEP adjustment indications are displayed.
2 Select the FM tuning step with 2/3.
Pressing 2/3 will switch the FM tuning step
between 50 kHz and 100 kHz. The selected FM
tuning step will appear in the display.
Note
• If seek tuning is performed in 50 kHz steps,
stations may be tuned in imprecisely. Tune in
the stations with manual tuning or use seek
tuning again.

Setting the AM tuning step

The AM tuning step can be switched between 9
kHz, the preset step, and 10 kHz. When using
the tuner in North, Central or South America,
reset the tuning step from 9 kHz (531 – 1,602
kHz allowable) to 10 kHz (530 – 1,640 kHz allow-
able).
1 Press 5 or ∞ to select
INIT MENU, and press
adjustment indications are displayed.
AM STEP
2 Select the AM tuning step with 2/3.
or
Pressing 2/3 will switch the AM tuning step
between 9 kHz and 10 kHz. The selected AM
tuning step will appear in the display.
from the
FM STEP
.
A.MENU
from the
AM STEP
.
A.MENU

Advertisement

Table of Contents
loading

This manual is also suitable for:

Avh-p6450cd

Table of Contents