Philips DVDR880 User Manual page 24

You can connect additional devices such as decoders, satellite receivers, camcorders, etc. to the
EXT 2 AUX I/O socket. When playback is started on this additional device the DVD recorder
automatically connects the EXT 2 AUX I/O scart socket with the EXT 1 TO TV-I/O scart
socket. You will then see the picture from the additional device on your TV set, even if the
DVD recorder is switched off.
The TV/DVD button on the remote control allows you to switch between playback through the
EXT 2 AUX I/O scart socket and playback from the DVD recorder.
You can connect a video recorder to the EXT 2 AUX I/O socket. If you have an SVHS video
recorder you can additionally use the OUT S-VIDEO (Y/C) socket and the OUT L AUDIO
R sockets.
Most pre-recorded video cassettes and DVDs are copy-protected. If you try to copy them you
will see the message '
a
b Check that the scart cable is plugged in firmly.
b The DVD recorder may not be able to recognise the video input signal if
this signal is poor or does not comply with relevant standards.
a
b This happens if you try to copy DVDs or video cassettes that have been
copy-protected. Even though the picture on the TV is fine the recording on
a DVD+R(W) is faulty. This interference is unavoidable with copy-protected
DVDs or video cassettes.
' on the DVD recorder's display.
Connecting the DVD recorder