The Model 2035 is simple to install and designed for excellent
reliability. The following instructions will help you set up and install the
converters properly. If you have any questions, please call Patton
Technical Support at (301) 975-1007.
3.1 CONFIGURATION SWITCHES
The Model 2035 uses a set of eight external DIP switches (see
Figure 1, below) that allow configuration to a wide range of
applications. Because all eight switches are in one externally
accessible DIP switch package, there is no need to open the case for
configuration. The configuration switches allow you to select data
rates, parity, word length and flow control selection. The following
section describes all switch locations, positions and functions.
Figure 1. The location of the Model 2035 configuration switches
The Model 2035 uses a miniature configuration switch package.
To configure your unit, use a small screwdriver and gently push each
switch to its proper setting. The ON and OFF positions are shown in
Figure 2., below. Default settings for the DIP switches are shown in the
table on the following page. Detailed settings follow the table.
Figure 2. The miniature configuration switch package
3.0 CONFIGURATION
1 2 3 4 5 6 7 8
OFF
4
Configuration
Switch