Characters may be up to 11 bits long. All warranty and non-warranty repairs must be returned freight Measuring only 3.2” x 2.0” x .75”, the Model 2010 is housed in a prepaid and insured to Patton Electronics. All returns must have a sturdy ABS plastic case.
The four switches shown in Figure 2 allow selection of character length and extended signalling rate. These switches are located SWITCH SUMMARY TABLE internally on the Model 2010’s PC board. To access them, use a small flathead screwdriver to pop open the Model 2010’s case as shown in Position...
Switch SW1-3: Extended Signalling Rate (ESR) The Model 2010 is designed to be used in pairs , with one unit The setting for switch 1-3 determines the range of variability the installed between an asynchronous DTE and a synchronous DCE on Model 2010 looks for in asynchronous data rates (i.e., the actual...
Receive Data (from 2010); data output to asynchronous port before dropping RTS, making the Model Request to Send (to 2010); input to the 2010 power supply 2010 usable in a polling environment Clear to Send (from 2010); connected straight through to...
Frame Ground; connected straight to asynchronous port Transmit Data (from 2010); data output to synchronous port Receive Data (to 2010); data input from the synchronous port; input to 2010 power supply Request to Send (from 2010); 4 bit delay from asynchronous port (2010 waits 4 bits before dropping RTS to the synchronous port;...