Table of Contents
Advertisement
5.0 OPERATION
Once you have configured each Model 2085RC and connected the
cables, you are ready to operate the units. Section 5.0 describes the
LED status monitors and the power-up procedure.
5.1 LED STATUS MONITORS
The Model 2085RC features front panel LEDs that indicate the con-
dition of the modem and communication link. Figure 6 (below) shows
the positions of the LEDs.
Model 2085RC
Power
Unit
A
Unit
B
Figure 6. The Model 2085RC front panel, showing LED positions
•
The green "PWR" LED glows when power is applied to
the modem through its mid-plane chassis connection.
•
The green "TD" and "RD" LEDs show positive state data
activity. The red "TD" and "RD" LEDs show negative state
data activity. A solid red light indicates an idle state.
•
The green "CD" LED lights when the receive carrier is
detected; the red LED lights when the receive carrier is
absent.
5.2 POWER-UP
There is no power switch on the Model 2085RC: Power is automat-
ically applied to the 2085RC when its card-edge connector touches the
chassis' mid-plane socket, or when the chassis' power is turned on.
NOTE:
The 2085RC is a "hot swappable" card—it will not be
damaged by plugging it in or removing it while the rack is pow-
ered up.
TD
RD
CD
TD
RD
CD
19
APPENDIX A
PATTON ELECTRONICS MODEL 2085RC
SPECIFICATIONS
Transmission Format:
Asynchronous
Data Rate:
0 to 115.2 Kbps
Control Signals:
DSR turns "ON" immediately after the
terminal raises DTR; DCD turns "ON"
after recognizing the receive signal
from the line; CTS turns on after the
terminal raises RTS
Transmission Line:
2-wire or 4-wire, unconditioned twisted
pair
Transmit Mode:
Full or half duplex
Transmit Level:
2V ± 10% differential output voltage
Carrier:
Constantly on or controlled by RTS
RTS/CTS Delay:
8 msec or zero
Echo Mode:
Echo and No Echo, supported in both
2-wire and 4-wire modes
Receiver Impedance:
Low (120 ohms), High (100k Ohms)
Line Connection:
RJ-11 or RJ-45 jack
Surge Protection:
Compliant with IEC 801.5 level 2,
1kV
Power Supply:
Rack-mount power supply is
switchable between 120V and 240V
AC; rack chassis supplies 10V AC to
the Model 2085RC, typical
consumption is 700 mW per card
Fuse:
400mA for 120V applications; 200mA
for 240V applications
Temperature Range:
0-50°C (32-122°F)
Altitude:
0-15,000 feet
Humidity:
Up to 95% non-condensing
Dimensions:
0.95"w x 3.1"h x 5.4"l
20
Advertisement
Table of Contents
