Advertisement
WARRANTY
Patton Electronics warrants all Model 460 components to be free
from defects, and will—at our option—repair or replace the product
should it fail within one year from the first date of shipment. This
warranty is limited to defects in workmanship or materials, and does not
cover customer damage, abuse or unauthorized modification. If this
product fails or does not perform as warranted, your sole recourse shall
be repair or replacement as described above. Under no condition shall
Patton Electronics be liable for any damages incurred by the use of
this product. These damages include, but are not limited to, the
following: lost profits, lost savings and incidental or consequential
damages arising from the use of or inability to use this product. Patton
Electronics specifically disclaims all other warranties, expressed or
implied, and the installation or use of this product shall be deemed an
acceptance of these terms by the user.
SERVICE AND SUPPORT
All warranty and non-warranty repairs must be returned freight
prepaid and insured to Patton Electronics. All returns must have a
Return Materials Authorization number on the outside of the shipping
container. This number may be obtained from Patton Electronics
Technical Service at (301) 975-1007; http://www.patton.com: or,
support@patton.com. NOTE: Packages received without an RMA
number will not be accepted. Patton Electronics' technical staff is also
available to answer any questions that might arise concerning the
installation or use of your Model 460. Technical Service hours: 8AM to
5PM EST, Monday through Friday.
CE NOTICE
The CE symbol on your Patton Electronics equipment indicates
that it is in compliance with the Electromagnetic Compatibility (EMC)
directive of the European Union (EU). A Certificate of Compliance is
available by contacting Patton Technical Support.
PRODUCT DESCRIPTION
The Patton Model 460 Series allow 75 Ohm coax hardware to
communicate with 120 Ohm twisted pair equipment. The Model 460
Series specifically address the ONP requirement that European PTTs
offer 120 Ohm twisted pair terminations to their customers. Some PTTs
and private carriers are standardized on 75 Ohm coax, or have
customers whose CPE has only 75 Ohm coax connections. The Model
460 Series present a ready solution to this termination mismatch by
allowing a bi-directional conversion of coax (75 Ohm) to a twisted pair
(120 Ohm ), supporting data rates to E1 (2.048 Mbps). The signals
1
output by them are scaled to match the pulse shape requirements
specified by the CCITT G.703 standard.
The Model 460s come in the following versions (see below):
460
· A shielded RJ-45 jack.
· 460M:Two male coaxial connectors (i.e., center conductor is
a pin).
· 460F:Two female coaxial connectors (i.e., center conductor is
a receptacle).
460-TBP
· A 4-position terminal block.
· 460M-TBP:Two male coaxial connectors (i.e., center
conductor is a pin).
· 460F-TBP:Two female coaxial connectors (i.e., center
conductor is a receptacle).
460MC
· Two male coaxial connectors at the end of a coax pigtail
cable. (i.e., center conductor is a pin).See photo on front
cover of manual.
Terminal block
Gaithersburg, Maryland
Model 460F-TBP
G.703 Balun
S/N:9912130009 Lot: 00774
R C
V
X M
T
RX In
TX Out
Model 460-TBP
RJ-45 connector
Gaithersburg, Maryland
Model 460
G.703 Balun
S/N:9912130035 Lot: 00784
RX In
TX Out
Model 460
2
TX Out connector
Rx In connector
TX Out connector
Rx In connector
Advertisement
