Operation; Power-Up; Led Status Monitors - Patton electronics 2701/I User Manual

When the Model 2701/I has been properly configured and installed, it
should operate transparently. This sections describes power-up, LED
status monitors, and the built-in loopback test modes.

6.1 POWER-UP

Before applying power to the Model 2701/I, please read section 5.4,
"Power Connection" on page 20 and ensure that the unit is properly con-
nected to the appropriate power source..

6.2 LED STATUS MONITORS

The Model 2701/I features six front panel LEDs that monitor connections
on the G.703/G.704 and 10BaseT links, signaling, error and test modes.
Figure 10 (below) shows the front panel location of each LED. Descrip-
tions of each LED follow Figure 12.
E1 Link
(Active Green) Solid green (On) indicates that the end to end E1
Link is up, signifying that the link is active. The E1 Link LED is
Off when the link is down.

6.0 OPERATION

Figure 12. 2701/I Front Panels
21