Connecting The 10Base-T Ethernet Port To A Pc (Dte); Connecting The 10Base-T Ethernet Port To A Hub - Patton electronics 2701/I User Manual

5.2 CONNECTING THE 10BASE-T ETHERNET PORT TO A PC
(DTE)
Figure 8. Connecting the 10Base-T Ethernet Port to a PC
The 10Base-T interface is configured as DTE (Data Terminal Equip-
ment). If the Model 2701/I is to to connect to another DTE device such
as a 10Base-T network interface card, construct a 10Base-T crossover
cable and connect the wires as shown in the diagram below (Figure 9).
Figure 9. 10Base-T Cross-over Cable Connection

5.3 CONNECTING THE 10BASE-T ETHERNET PORT TO A HUB

The 10Base-T interface is configured as DTE (Data Terminal Equip-
ment), just like a 10Base-T network interface card in a PC. Therefore, it
"expects" to connect to a 10Base-T Hub using a straight-through RJ-45
cable. Use the diagram below (Figure 10) to construct a cable to con-
nect the 10 BaseT interface to a 10Base-T Hub.
Figure 10. Connecting the 10Base-T Ethernet Port to a Hub
19