Configuration; Dip Switch Configuration - Patton electronics 2701/I User Manual

4.0 CONFIGURATION

The Model 2701/I features configuration capability via hardware DIP
switches. This section describes all possible DIP switch configurations of
the Model 2701/I.

4.1 DIP SWITCH CONFIGURATION

The Model 2701/I has two sets of internal DIP switches that allow config-
uration for a wide range of applications. The sets of switches are
accessed from the underside. Figure 3 shows the location of the DIP
switches on the bottom of the printed circuit board.
Figure 3. Underside of Model 2701/I, Showing Location of DIP Switches
The Model 2701/I DIP switches (Switch Sets 1-2) can be configured as
either "ON" or "OFF". Figure 4 shows the orientation of the DIP switches
with respect to ON/OFF positions.
Figure 4. Close up of configuration switches
11