Panasonic EASA-PHONE KX-T123210 Installation Manual page 85

....................... until the desired CO number (01 through 12) appears
l
.....................................
until the desired dial mode appears
DTMF Mode.............. default (all 12 CO' s)
Pulse Mode
: to assign the same on all 12 CO' s
Description
Allows the user to select the dialing mode (tone
or pulse) of each CO (Central Office) line.
0 DTMF Dial Mode
0
The dial signal from the extension (with tone
or pulse dial mode) will be converted to TONE.
TONE will be transmitted to the Central Office.
PULSE Dial Mode
The dial signal from the extension (with tone
or pulse dial mode) will be converted to PULSE.
PULSE will be transmitted to the Central Office.
Programming
1. Dial (41).
" CO Dial Mode" will be displayed.
2. Press the NEXT button.
' CO NO ?-," will be displayed.
3. Press the NEXT button or dial the CO number
(01 through 12).
" CO 01 : DTMF Mode" will be displayed and
" DTMF Mode" will blink.
4. Repeat pressing the SELECT button until the
desired dial mode isdisplayed.
5. Press the MEMORY button.
The LCD will stopblinking,
6. o
0
0
To advance to the next CO number,
press the NEXT button.
To return to the previous CO number,
press-the PREV button.
To go to the desired CO number,
press the SELECT button and then dial the
CO number.
3-43
7. Repeat Steps 4 to 6, to propgram the dialing
mode on the other central office lines.
8. To return to the initial program mode, press
the END button.
Conditions
l If the KX-Tl23210 is connected to the Central
Office directly or installed behind a host PBX,
which receives both tone and pulse dialing
mode, the KX-T123210 must be used only in
the tone dial mode.
0 If your extension is not a Proprietary
telephone but a standard telephone, and the
dial tone frequency of CO Lines is 600H2, the
KX-T123210 must be used only for the pulse
dialing mode for the CO Lines.
Example:
l TONE on the CO 1=
I7i-lINEXTII011Il
or
piil4111NEXTj
o PULSE on the CO 2=
1411INEXT11021m
or
Programming Table
See page 7-9.