Lifting Instructions - Trane CLCH-IM-16A Installation And Maintenance Manual

Table 20
Unit Size 80, Approximate Dry Coil Weights, Fin Series 168 (Weights in lb)
Rows W K
2 873 932
4 1471 1643
6 2068 2355
8 2664 3066
10 3262 3777
12 3859 4490
Table 21
Unit Size 100, Approximate Dry Coil Weights, Fin Series 168 (Weights in lb)
Rows W K
1 729
2 1065 1131
4 1815 2010
6 2565 2889
8 3315 3771
10 4062 4653
12 4812 5529

Lifting Instructions

The Trane Company recommends that the contractor
use spreader bars and slings to rig units and
subassemblies (sections) as shown.
q Always assemble the unit at the installation site.
q Always rig subassemblies or sections as they ship
from the factory.
q Make the loop of the sling parallel to the direction
of airflow, whenever possible.
The following instructions cover lifting the unit as well
as inlet and exhaust hoods and external pipe chases.
Follow specific instructions.
WARNING
Follow good lifting practices
before lifting the unit to include
following instructions in this man-
ual, estimating center of gravity,
12
Coil Type
P2 P4 P8
1547
2219
2893
3565
4268
Coil Type
P2 P4 P8
N/A N/A N/A
1900
2733
3570
4404
5238
D DD WD WA
778
1516
2275 2114
2872 2710
3632 3307
4228 3904
D DD WD WA
546
945
1866
2802 2613
3552 3363
4488 4113
5238 4863
and test lifting the unit to check
balance and stability.
Do NOT use fork lifts for handling
units.
Never lift units in windy conditions
or raise units above personnel.
Failure to follow all instructions
may result in personal injury or
equipment damage.
1 Before lifting the unit, estimate the approximate
center of gravity and test lift the unit to determine
balance and stability.
NOTE: PREPARATION OF THE ROOF CURB OR PIER
MOUNT AND ROOF OPENINGS SHOULD BE
COMPLETED BEFORE LIFTING UNIT TO THE ROOF.
SEE THE ASSEMBLY SECTION OF THIS MANUAL.
WC NS
WC NS
603 909
CLCH-IM-16A