TP-Link TL-WA701ND User Manual page 41

2. Configure the Switch.
Enable 802.1Q Tag VLAN function on the switch.
Make sure the Untag frames are forwarded.
The following table shows the detailed configuration for the switch
Port VLAN ID
1 1
2 2
3 3
4 4
Port5 belongs
5
VLANs
Connect PC1, PC2, PC3 and PC4 to port1, port2, port3 and port4 of the switch respectively.
The corresponding VLAN IDs of the four ports are 1, 2, 3 and 4.
Configure port5 of the switch to be the member of VLAN1, VLAN2, VLAN3 and VLAN4 and
connect it to the LAN port of TL-WA701ND.
Configure the VLAN ID of the PC that can log on to the Web management page of
TL-WA701ND via the LAN port equal to the PVID of port 5.
3. Verify the communication status after the above configuration is completed.
If VLAN ID of the PC connected to the switch is different from the VLAN ID of the wireless
STA, the two cannot communicate with each other, for example, PC1 and STA2.
If the PC connected to the switch and the wireless STA have the same VLAN ID, the two can
communicate with each other, for example PC2 and STA2.
TL-WA701ND 150Mbps Wireless N Access Point User Guide
PVID Egress Rule
1 Untag
2 Untag
3 Untag
4 Untag
to all
1 Tag
Table 4-1 Configure the Tag VLAN Switch
Multi-SSID+VLAN
33
Processing mode
Frames
Forwarding
Forwarding
Forwarding
Forwarding
Forwarding
of Utag