Correct Use Of Chain Brake - Echo CS-355T Instruction Manual

Chain brake function
When the lever is pushed forward, chain brake
instantly stops the chain.
Chain brake unlock
When the lever is fully pulled toward the
operator, brake is unlocked.
The installation of a chain brake may be mandatory by
law or as stipulated by insurance regulations in your
area of operation. You should inquire through local
government offices, your employer or your local dealer
to ensure that your chain saw conforms to the required
safety standard.
ECHO chain brakes have been designed and tested to
comply with international safety standards as follows.
This model needs to use low-kickback chain and bar.
USA : ANSI
Safety Requirement for chain saws
ANSI Standard B175.1 stipulates that the brake shall
stop the chain 0.12 seconds at an engine speed
of 13500 r/min. It is the responsibility of the owner/
operator to ensure that the brake is serviced, adjusted
and tested strictly in accordance with the instructions
as detailed herein in order to ensure that the brake
performance is maintained in compliance with the
Standard B175.1.

CORRECT USE OF CHAIN BRAKE

Standard B175.1
warning
CHain BraKE OPEraTiOn
• Set the lever in the unlocked position before start-
ing to cut.
• If the brake is tripped by kickback reaction, the
chain will stop immediately. Release the throttle to
avoid possible damage to the engine or clutch.
• Do not attempt to operate the engine with the brake
locked.
TESTing THE BraKE
• Start the engine on a solid level surface and run at
a fast idle until warm.
• Hold the saw firmly by the handles and accelerate
the engine to a fast idle.
• Slowly operate the chain brake lever while holding
the saw firmly on the ground. When the brake lever
trips, the chain should stop. Immediately release
the throttle trigger.
iMPOrTanT
Do not allow the saw to tip forward in order to avoid
damage to the chain.
warning
If the chain does not stop immediately, return the
saw to your authorized ECHO dealer for repair.
nOTE
• For practice, while cutting a small tree, push the
lever forward to lock the brake.
• Confirm that the brake works properly before each
use.
• If the chain brake is clogged with wood chips,
function of the brake may deteriorate. Always
keep the device clean.
• Do not increase engine speed while the chain
brake is locked.
5
CS-355T