Chain And Guide Bar Combination - Echo CS-355T Instruction Manual

CHAIN AND GUIDE BAR COMBINATION

The following combinations are recommended for model CS-355T.
Length mm (in)
305 (12)
356 (14)
406 (16)
warning
Use of replacement saw chain and/or guide bar other than that specified, or operation without the "tip guard" in place,
may cause severe kickback resulting in serious injury.
Only use saw chain designated as, "LOW-KICKBACK," that meets the B175.1 Standards when tested on the rep-
resentative sample of chain saws below 3.8 C.I.D., and the Echo guide bar specified.
iMPOrTanT
Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table above.
iMPOrTanT
If your kick guard is damaged or lost, contact your Echo dealer for a replacement. For the name of the
Echo dealer nearest you, Call: 1-800-432-ECHO (3246) or on the web at www.echo-usa.com.
Refer to your Chain Saw Safety Manual for kick guard application information.
GUIDE BAR
(Low-kickback)
Replacement guide bars.
The following guide bars may be considered to have
equivalent kickback energy.
• Sprocket nose guide bars of the same length and
nose radius, same pitch and having the same
number of teeth.
• Hard nose guide bars of the same length and
nose radius as a sprocket nose bar.
Guide bar
Part No.
12A0ED3745
14A0ED3752
16A0ED3757
Pitch mm (in) Part No.
9.53 (3/8) 91PX45CQ
9.53 (3/8) 91PX52CQ
9.53 (3/8) 91PX57CQ
SAW CHAIN
(Low-kickback)
CAUTION
Do not use replacement saw chain unless
it has been designated as meeting the ANSI
B175.1 kickback performance requirements,
when tested on the representative sample of
chain saws below 3.8 c.i.d. specified in ANSI
B175.1.
NOTE
LOW KICKBACK SAW CHAIN meets the
kickback performance requirements of B175.1
(safety requirements for gasoline-powered
chain saws).
23
Saw chain
Links
45
52
57
CS-355T