Preparation For Use - Echo CS-355T Instruction Manual

(A)
(D)
(E)
(F)
Brake lever
(Front hand guard)
Brake connector
Two nuts
Clutch cover

PREPARATION FOR USE

Saw chain is sharp! always wear gloves when
handling assembly, otherwise serious personal
injury may result.
nOTE
The machine may be delivered with guide bar, tip
guard, and saw chain separated. Install guide bar, tip
guard, and saw chain as follows.
KiCK gUarD
TiOnS
Tools Needed: Two 11 mm (7/16 in.) Wrenches.
For saws with Kick guard
metrical Low-Kick type (Double guard) guide bars.
(B)
1. Install bolt (A) in rear hole (B) of Kick Guard
(C)
2. iMPOrTanT: Dimple (D) in Kick Guard
3. Tighten nut (F) and bolt (A) using 11 mm (7/16 in.)
4. Tighten nut (F) 1/8 additional turn.
5. Check to make certain Kick Guard
gUiDE Bar anD Saw CHain inSTaL-
LaTiOn/rEMOVaL
nOTE
• Move the chain brake lever (Front hand guard) fully
• Align the brake connector of the clutch cover to the
1. Remove spark plug cover and disconnect spark plug
2. Remove two clutch cover nuts and remove clutch
3. Remove bar and saw chain if necessary. See "Main-
13
warning
TO Bar inSTrUC-
®
through front hole (C) in guide bar.
recess (E) in guide bar.
wrenches until snug. Make certain Kick Guard
against guide bar.
bar.
rearward to remove or install the clutch cover to
chain saw.
groove on the side of the brake lever (Front hand
guard).
lead.
cover.
tenance and Care" section for guide bar/saw chain
maintenance procedures.
P/n 2894901 and Sym-
®
and
®
must engage
®
is flush
®
is tight on guide
®
CS-355T